Crystal XP2i 2nd Generation - Manual (Page 17)

Specifications  15
XP2i Operation Manual
„ „
Pressure ranges, dIsPLay scaLes, & resoLutIon
PSI bar kPa Overpressure PsI inH
2
0 inHg mmHg mmH
2
0 kg/cm 2 bar mbar kPa MPa
15PSI 1BAR 100KPA 6.5 x 0.001 0.01 0.001 0.01 1 0.0001 0.0001 0.1 0.01
30PSI 2BAR 200KPA 3.0 x 0.001 0.01 0.001 0.1 1 0.0001 0.0001 0.1 0.01
100PSI 7BAR 700KPA 2.0 x 0.01 0.1 0.01 0.1 1 0.0001 0.0001 0.1 0.01
300PSI 20BAR 2KKPA 2.0 x 0.01 0.1 0.01 1 0.001 0.001 1 0.1
500PSI 30BAR 3KKPA 2.0 x 0.01 1 0.1 1 0.001 0.001 1 0.1
1KPSI 70BAR 7KKPA 2.0 x 0.1 0.1 0.001 0.001 0.1
2KPSI 140BAR 14KKPA 2.0 x 0.1 0.1 0.01 0.01 1 0.001
3KPSI 200BAR 20KKPA 1.5 x 0.1 0.1 0.01 0.01 1 0.001
5KPSI 300BAR 30KKPA 1.5 x 0.1 1 0.01 0.01 1 0.001
10KPSI 700BAR 70KKPA 1.5 x 1 0.01 0.01 1 0.001
•
Unneeded pressure units may be disabled via the RS-232 connector using ConfigXP software.
•
kPa models can display pressure in kPa and bar (or mbar) only. PSI and bar models can display all available units.
•
An XP2i will indicate pressure up to 10% above Range Pressure. Above 110%, the XP2i display will flash, indicating that the applied pressure exceeds the
calibrated pressure range. If the calibrated pressure range is exceeded, the pressure displayed may not be accurate.
•
MPa is available on -DD models only.
•
An Absolute pressure version is available only on XP2is and XP2i - DDs with ranges of 2000 PSI and higher.
„ „
ModeL nuMBerIng systeM
P/n Model
Adapter:
type
Connection:
Location
Panel Mount? data-logging?
XP 2I
NPT: (omit) Bottom: (omit) No: (omit) No: (omit)
G 1/4 B: -BSP Back: -RP Yes: -F4 Yes: -DL
"omit" for -F4
panel mount Includes
-RP option
SAMPLE PART NUMBERS
300PSIXP2I . . . . . . . . . . . . . . . 300 PsI standard gauge
500PSIXP2I-BSP . . . . . . . . . 500 PsI gauge, with a 1/4” BsP pressure fitting -RP option Rear Pressure Fitting -F4 option Panel Mount Flange