Blue-White Micro-Flo - Manual (Page 10)

MICRO-FLO
Page 10
7.2 Programming for body size/ranges S1through S6 -
Press and Hold ENTER to initiate the programming mode.
1 S BODY SIZE/RANGE - Select your body size. Selected body size flashes.
Press and release to select. ML > OZ > GAL > LIT
1
0
ML
R Min
2
0
ML
R Min
Press and release to select. S1 > S2 > S3 > S4 > S5 > 6 > S0
Note: Select S0 for field calibrating any body size range. S
Press and release to select. 0 > 0.0 > 0.00 > 0.000 > 0.0000
3
0
ML
R Min
Press and release to select. Min > Hr > Day
RATE UNIT OF MEASURE - current unit of measure setting flashes
RATE DECIMAL LOCATION - current decimal display setting flashes.
1
0
ML
T
RATE TIME BASE - current time base unit of measure setting flashes.
2 ML
T
3
RST Y
T
Press and release to select. Y > N
TOTAL RESET ENABLE - current Y (yes) or N (no) setting flashes.
TOTAL UNIT OF MEASURE - current unit of measure setting flashes
Press and release to select. ML > OZ > GAL > LIT
Press and release to select. 0 > 0.0 > 0.00 > 0.000 > 0.0000
TOTAL DECIMAL LOCATION - current decimal display setting flashes.
0
1
off
R SetP
ENTER
ALARM SETPOINT ENABLE - current ON or OFF setting flashes.
If “off”
If “on”
2
000000
R SetP CLEAR
CAL /
ENTER
p
000.000
R SetP
ENTER
Press and release to select the digit to change.
ALARM SETPOINT VALUE - current value setting flashes.
CLEAR
CAL /
ENTER Press and hold ENTER then press CLEAR
to change the selected digit.
Press and release to select. 0 > 0.0 > 0.00 > 0.000
> 0.0000
ALARM VALUE DECIMAL LOCATION - current decimal
display setting flashes.
CLEAR
CAL /
ENTER
CLEAR
CAL /
Press and release to select. ON > OFF
ENTER
CLEAR
CAL / ENTER
CLEAR
CAL / ENTER
CLEAR
CAL /
ENTER
CLEAR
CAL / ENTER
CLEAR
CAL /
ENTER
CLEAR
CAL / ENTER
CLEAR
CAL /
If range S1 through S6 is selected, return to program screen or
press and hold ENTER to exit the programming mode.
If range “S0” is selected, continue to field calibration procedure, next page.