Badger Meter ORION AMR/AMI Hardware Solutions for Gas Utilities - Manual (Page 6)

ORION® Gas Endpoints, Integral Endpoint for Itron®/Actaris® Residential Slope-Face Gas Meters
LICENSE REQUIREMENTS
This device complies with Part 15 of FCC Rules Operation of this device is subject to the following conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation
IN ACCORDANCE WITH FCC REGULATIONS, “CODE OF FEDERAL REGULATIONS” TITLE 47, PART 2, SUBPART J, SECTION
1091, TRANSMITTERS (ENDPOINTS) PASS THE REQUIREMENTS PERTAINING TO RF RADIATION EXPOSURE. HOWEVER,
TO AVOID PUBLIC EXPOSURE IN EXCESS OF LIMITS FOR GENERAL POPULATION (UNCONTROLLED EXPOSURE), A 12 CM
DISTANCE BETWEEN THE TRANSMITTER (ENDPOINT) AND THE BODY OF THE USER MUST BE MAINTAINED
DURING TESTING.
No FCC license is required by a utility to operate an ORION meter reading system
This device complies with Industry Canada license-exempt RSS standard(s) Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement
Any changes made, but not approved by Badger Meter, can void the user’s authority to operate the equipment
INSTALLATION TOOLS AND MATERIALS
Use magnetized screwdrivers:
• 1/8" flat screwdriver
• 1/4” flat screwdriver
• #1 Phillips screwdriver
OTEE: N If a battery powered driver is used, ensure torque maximums are not exceeded (usually 15 inch-pounds)
Putty knife or flat blade scraper
Badger Meter handheld programmer/data collector
LABEL INFORMATION
Certification markings are noted on the product label Label markings include:
• Serial number and bar code plus product description
• FCC identification
• Certification markings
Page 6 July 2014