Audient ASP4816 - Compact Analogue Recording Console - Manual (Page 26)

Page -26- © Audient Ltd
Console functions.
INPUT CONNECTORS
The rear mounted connector panel
is where the input, output and insert
point connectors are located.
The microphone input uses an XLR
connector while the line input, DAW
input and the insert sends and returns
use Tip, Ring and Sleeve jacks.
1 MICROPHONE INPUT.
Microphones or other low
levels inputs can be connected
to this input.
2 LINE INPUT. This input can
be selected in place of the
microphone input. Like the
DAW input it is suitable for
high level line sources.
3 MIC/LINE INSERT SEND .
This is the insert point send
output for the microphone and
line input. Signal is always
present here and can be used
as an additional output. Only
the Mic/Line signal will appear
here and it is not affected by
the Flip switch.
4 MIC/LINE INSERT RETURN.
When the insert point is in use
the signal from the external
processing equipment should
be connected here.
5 DAW INPUT. The output of
the DAW should be connected
here although the input is
suitable for any high level line
source.
6 DAW INSERT SEND. This
is the insert point send output
for the DAW input. Signal is
always present here and this
can be used as an additional
output. Only the DAW signal
will appear here and it is not
affected by the Flip switch.
7 DAW INSERT RETURN.
When the insert point is in use
the signal from the external
processing equipment should
be connected here.
CHANNEL STRIP