Thermo Fisher Scientific CyberComm Pro for CyberScan pH 1500 - Manual (Page 15)

Instruction Manual CyberScan pH 1500
12
Icon 11: Meter Settings
See Figure 16.
Program your meter functions via this icon on
CyberComm Program.
a) pH
Resolution
Select from 1 to 3 decimal places.
b) Temperature
Scale
Select °C or °F as required.
c) Stability
Check box to enable the Stability Indicator
d) Good Laboratory Practice Settings
Enter the relevant information for useful future
references.
e) Reset pH calibration settings to default
Check box & click apply to reset pH calibration
settings.
Click on OK or Apply to save settings whenever there are changes.
Continue from Section 4.2
Refer back to Figure 12 on pg 13.
4.2.2 Measurement
Mode
This indicates the current mode of measurement of the meter, you can change the mode by selecting from
the drop down menu to choose between the various parameters; pH, mV and REL mV.
4.2.3 Show
Cursor
Use the ‘Show cursor’ function from the icon panel and a green guide line will show any point on the reading
curve having the exact measurement according to the mode chosen. Drag this guide along the horizontal
time axis and you can read the pH, mV or concentration values at any point in time.
4.2.4 Information
This information will always be on the graph, showing the Elapsed Time of the measurement being carried
out, the date and time which marks the start of the first data captured.
4.2.5 Data Reading
The data captured from the meter is plotted on the graph while the measurement is being carried out.
4.2.6 Temperature
Reading
This curve shows the temperature in which the measurement is carried out simultaneously. You can choose
to view the reading with or without the temperature curve by clicking on the ‘Show/Hide Temperature’ icon on
the icon panel.
4.2.7 Mode Drop down Menu
Change Mode of Measurement by selecting the preferred parameter from this drop down menu.
Figure 16: Meter Settings