Thermo Fisher Scientific CyberScan pH 11/pH 110 - Manual (Page 47)

Instruction Manual CyberScan pH 11 / 110
43
NOTE:
Calibration reset is independent for each measurement parameter.
That is:
• From pH mode, calibration reset will only erase pH calibration
values; and
• From mV mode, calibration reset will only erase mV calibration
values.
9.6.2 User Reset
This program clears all data including calibration,
memory and other customised setup functions and reset
it to factory default.
You can skip program P5.1 (Calibration Reset) and
proceed straight to Program P5.2:
1. From Program P5.0 - rSt, press HOLD/ENTER
key three times to P5.2. Press HOLD/ENTER
key again to enter the User Reset menu.
2. Press the MI/▲ or MR/▼ keys to select or
deselect the user reset function.
• ‘NO’ retains current settings
• ‘YES’ resets to factory default settings.
3. Press the ENTER key to confirm selection.
• If ‘NO’ is selected, it will retains current
settings and goes back to program 5.0.
• If ‘YES’ is selected, all LCD segments will lit
up for one second, resets to factory default
settings, and the meter will be in the
measurement mode.
4. Otherwise press CAL/MEAS key to return to
measurement mode without resetting to factory
default.
yes
SETUP
SETUP
SETUP
P 5.2
ENTER
HOLD
MI MR
Select either "YES" or "nO",
press ENTER key to confirm.
Figure 39: P5.2 - User reset