Thermo Fisher Scientific CyberScan pH 11/pH 110 - Manual (Page 11)

Instruction Manual CyberScan pH 11 / 110
7
3.2.2 To connect the temperature probe:
The temperature probe (provided) uses a 2.5 mm
phono jack to connect with the socket on the pH
11/110. Insert the jack fully into the socket (Figure
6).
Note: Calibrate your temperature probe when you
replace the probe and when using a “3-in-One”
combination pH and temperature probe. See
section 4.5 - Temperature Calibration on page 16
for instructions.
3.2.3 Attaching the Electrode Holder to the
Meter
The pH meter is designed to allow you to do a one hand operation for any
measurement or calibration. For that purpose, two electrode holders are provided.
They are designed for easy use and installation. Care must be taken to avoid use of
excessive force in the process of attaching these components.
1. Locate the slot on the right-hand side of the meter.
2. Gently slide the flange of the holder into the slot on the meter. Make sure the
holder is secured properly into the slot (Figure 7).
3. You can attach the electrode holder in different positions (Figure 9).
3.2.4 To attach a second electrode holder:
The electrode holder is designed such that you can attach one holder onto another.
Up to two electrodes (using the BNC connector and phono-jack) can be used with the
meter at any one time.
Figure 6: Insert temperature probe
Figure 7: Insert electrode holder