Techne HB-1D - Manual (Page 22)

22
SETTING THE TEMPERATURE
1. To display the set temperature, press the SET temperature button:
2. To increase the set temperature, hold down the SET temperature button and press the Increase
button.
3. To decrease the set temperature, hold down the SET temperature button and press the Decrease
button.
Each press of the Increase or Decrease buttons will increase or decrease the set temperature by
0.1°C. If the buttons are held down the temperature change will accelerate to 5°C per second.
Note: It takes approximately 50 minutes for the interior of the hybridisation tubes to reach the
displayed temperature depending upon the number of filters and amount of hybridisation fluid used.