Revo RECLKSD-1 User Manual
Page 7
5
Start the Device
z
After the Alarm Clock DVR has been connected to the power supply, please check the
time displayed. You will have to manually set the correct time and alarm.
z
Time is displayed in PM; A “PM” indicator will appear on the display for PM time
only and when PM is not displayed this indicates that the time is AM.
z
Alarm symbol (
) appear on the display indicates that the alarm has been setup to
activate at the preset time.
Set the Clock
z
Slide the switch to the TIME (4) position.
z
Press and hold the HOUR button (1) to advance to the desired hour. A “PM” indicator
will appear on the display for PM time only.
z
Press and hold the MINUTE button (2) to advance to the desired minute.
z
Slide the mode switch to LOCK position (4) to complete the clock time setting.
Set the Alarm Time
z
Slide the switch to the ALARM (4) position.
z
Press and hold the HOUR button (1) to advance to the desired hour. A “PM” indicator
will appear on the display for PM time only.
z
Press and hold the MINUTE button (2) to advance to the desired minute.
z
Slide the mode switch to LOCK position (4) to complete the alarm time setting.
Set the Alarm ON/ OFF
z
Move the Alarm ON/OFF (3) switch to ON position. The alarm symbol (
) will
appear on the display. The alarm will be activated at the preset time and sound for
8~9 minutes.
z
Move the Alarm ON/OFF (3) switch OFF position to shut off the alarm.
Snooze Operation
• Press the SNOOZE (5) button to delay the Alarm for 8~9 minutes after the alarm
sounds.
Cleaning the Device
z
Do not use polish solvents or strong detergents to clean the unit. The cabinet can be
cleaned with a piece of soft cloth soaked with little water. The power plug should
ALWAYS be disconnected from the main power supply during the cleaning.