Revo RECLKSD-1 - Manual (Page 16)

14
Motion Detection Area Setup:
Motion picture page is divided into (NTSC) 22x15 small detection blocks.
① Detection Area：One or more detection blocks forms a detection area.
② Cursor：Press《
Up 》 《Down》 《Left》 《Right》button to change the position of the cursor.
③ Setup Mode：Press《PLAY》button to edit detection block.
ADD ALL Enable all cells
DEL ALL Delete all cells
ADD AREA Enable detection area
DEL AREA Disable detection area
(1) ADD ALL and DEL ALL setup method, press《PLAY》 button to switch the mode
and press《Enter》button to complete the setup.
(2) ADD AREA and DEL AREA setup method, press《PLAY》button to switch the
mode and press《 Up 》 《Down》 《Left》 《Right》button to move the cursor to setup
the starting point of the block, press《Enter》button. Then move the cursor to
setup the ending point of the block, press《Enter》button to complete the setup.
(3) Detection area is indicated by green block and non-detection region by black
block.
NOTE: Detection block setting page, if the image changes within the detection area is higher than the warning value, then
the detection block turns to color red, and can be used as a reference for setting the sensitivity rate.
6.5 Manul Record and Schedule Record
Selectable manual or schedule recording, basic setups are shown below:
1. MANUAL RECORD: Press《REC》button to start recording.