Revo R4CMB-500 - Manual (Page 9)

4 Channel Digital Video Recorder
3
Chapter 2
— Installation & Configuration
REAR PANEL CONNECTORS
No special tools are required to install the DVR. Refer to the installation manuals for the other components that make
up part of your system. Your DVR should be completely installed before proceeding.
Built-In Speaker Stand Handle Factory Reset Switch
USB Port VESA Mounting Holes Power Cord Connector
Video Out Video/Audio In Network Port
Built-In Speaker
The built-in speaker sounds the DVR’s audio outputs.
Stand Handle
The stand handle will be used to adjust the angle of the stand. Loosen the handle first and then change the angle, and
tighten the handle again.
VESA Mounting Holes
The system is 75x75mm VESA compatible for wall mounting.
CAUTION: Wall mounting should follow the manufacturer's instructions, and should use a
mounting kit approved by the manufacturer.
Factory Reset Switch
This switch will only be used on the rare occasions that you want to return all the settings to the original factory settings.