Revo R4CMB-500 - Manual (Page 28)

User’s Manual
22
System Event Settings (EVENT  System Tab)
 Settings: Set up the DVR to run self-diagnostics.
System – Select the interval that you want the DVR to run
self-diagnostics on the system.
Check Recording – Selecting the column allows you to set up
the check recording schedule by selecting Schedule On.
Selecting
allows you to add a check recording schedule
by setting the day, time range and interval that you want the
DVR to run self-diagnostics on the recorder.
Selecting allows
you to delete a check recording schedule.
Disk Almost Full – Select the percentage level of disk usage
at which you want the DVR to trigger an alert.
Disk Bad – Select percentage level of bad disk sectors at which
you want the DVR to trigger an alert.
Disk Temperature – Set the temperature threshold and (ºC (Celsius) or ºF (Fahrenheit)). If the temperature of hard disk
drive exceeds the defined threshold, the system triggers an alert.
 Notify: Set up the notify action the DVR will take whenever it detects system events. System events can send an
e-mail or callback message to the remote sites.
NOTE: For the Notify action to work, the Mail and Push should be enabled in the NETWORK – Mail, Push setup.
DISPLAY SETUP
OSD Settings (DISPLAY  OSD Tab)
 Status/Camera: Check each OSD item box to turn it On
or Off.
Remote Control – The icon displays when the DVR can be
controlled using the infrared remote control.
Zoom – The icon displays on the enlarged video.
Network – The icon displays when the unit is connected to
a network via Ethernet. The icon displays when audio
communication is available between the DVR and a PC
running REVO Remote Pro
or REVO Remote via Ethernet.
Freeze & Sequence – The icon displays while in the Freeze
mode, and the icon displays while in the Sequence mode.