Camera setup, Record setup, Camera settings – Revo R4CMB-500 User Manual
Page 24: Record settings (record settings tab)

User’s Manual
18
CAMERA SETUP
Camera Settings
No.: Selecting the box toggles all or each camera On and
Off.
Title: Change the name of all or each camera.
RECORD SETUP
Record Settings (RECORD Settings Tab)
Recycle When Disk Full: Selecting this box records over
the oldest video data once all available storage space has
been used. When the box is not checked, the DVR stops
recording once all available storage has been used.
Resolution: Set the recorded image resolution. You can
select from High, High and Standard
NOTE: The total ips of all camera channels will be limited
to 60 ips when set to High resolution and 30 ips when
set to Very High resolution.
NOTE: When set to High or Very High resolution, the maximum recording speed of each camera channel might
decrease so as not to exceed the total ips of all camera channels. See the table below.
No. of cameras set to On and High resolution
0
1
2
3
4
─
30 ips
30 ips
20 ips
15 ips
No. of cameras set to On and Very High r solut
n
0
1
2
3
4
─
30 ips
15 ips
10 ips
7.5 i s
Record Audio: Selecting the box records audio from up to four inputs when video is recording.
Auto Deletion: Adjust the length of time recorded data will be kept by using the slide bar or Up and Down arrows
buttons. Selecting Never will disable the Auto Deletion function. The DVR automatically deletes video recorded
earlier than the user-defined period under three conditions: at midnight, whenever the system reboots or whenever
the user changes the Auto Deletion settings.
Schedule Settings (RECORD Schedule Tab)
The DVR provides two recording schedule modes: Basic and Advanced. The Basic schedule mode allows you to set
recording settings for all camera channels at one time. The Advanced schedule mode allows you to set recording settings
for each camera channel.