Pyromation Dual J-T-E-K - Manual (Page 20)

18
Single Probe Measurements
The displayed information depends on whether you
are using a single probe in the dual probe mode or
have changed to the single probe differential mode
by pressing the T1/T2 key.
If you are using a single probe and in the dual probe
mode, momentarily press the MIN
t
key. The MIN
annunciator turns on. If the probe is connected to
T1 the minimum reading will be shown in the lower
left display. If the probe is connected to T2 the mini-
mum reading will be shown in the lower right dis-
play. If a lower minimum occurs while in the MIN
mode, the lower reading will be displayed. To turn
off the minimum reading, press the MIN
t
key
again.
If you are in the single probe differential mode,
momentarily press the MIN
t
key. The MAX and
MIN annunciator turns on and both the maximum
and minimum readings appear in the lower displays.
The minimum will be on the left display and the
maximum on the right display. If a lower minimum
or higher maximum occurs while in the MIN mode,
the new readings will be displayed. To turn off the
minimum reading, press the MIN
t
key again.
Dual Probe Measurements
Momentarily press the MIN
t
key. The MIN an-
nunciator turns on, and both minimum T1 and T2
readings appear in the lower display. The T1 read-
ing is on the left display and the T2 reading is on
the right display. Press the MIN
t
key again to
cancel.
Clearing a Minimum Reading
Press the CLEAR key then press the MIN
t
key.
The minimum memory will be cleared.