NOSHOK 756 Series Digital Pressure Transmitters - Manual (Page 22)

19
6.2 Key Functions
6.3 The Programming Mode
The device can be programmed before or after installation.
The keypad is activated and the device can be programmed by simultaneously press-
ing the "esc" and "ok" keys (for 2 sec.). This method is used to access the main
menus. Each main menu has one or more sub-menus and each sub-menu, may have
its own sub-menus.
s n o i t c n u F n o t t u B
Main Menu Sub-menu Edit Functions
back to the previous
menu option back to the previous
menu option increase value
forward to next menu
option forward to next menu
option decrease value
back to value display
without saving back to main menu
without saving back to the sub-menu
without saving
to the sub-menu to the edit functions save value
activate keypad (push simultaneously; 2 s)
The keypad becomes inactive after 10 min. of disuse. All settings will de-
fault to previously stored values. Only settings that have been confirmed
with the "OK" function are stored.
A change in the starting measurement (zero point) has no effect on the
measurement span. Likewise, a change in the span has no effect on the
starting measurement.
An error signal occurs when the zero point or span settings fall outside of
the sensor’s nominal pressure range during calibration with pressure.
Nothing is saved.