Martel Electronics 320 - Manual (Page 10)

This gives the name of the owner of the calibrator.
The preceding display shows the default setting as the
calibrator is shipped. The name can be changed
through the operator setups. See page 24 for how to
change the owner’s name.
The next display will be:
Auto Calibration
in progress
This display will remain until the internal tests and
calibrations are finished. If the auto calibration
message fails to clear, the unit must be returned for
service. See page 54 for details. The next display will
be the functions that had been selected when the
calibrator was last used:
inH2O mA
0.0 0.000
This display indicates the calibrator is operating
properly and is ready to go to work.
8