3 cursor control / setpoint control – Martel Electronics PSC4010 User Manual

Page 11

2.3 Cursor control / Setpoint control

The output value can be controlled by the four cursor control arrows on the keypad. By
pressing one of the arrows a cursor will be added to the display under the last digit of the
output value. The left and right arrow keys are used to select which decade to be changed in
the output value. The up and down arrow keys are used to increase, decrease, or ramp the
output value.

The menu bar will change to the setpoint menu with the touch of any one of the four arrow
keys.

The three function keys are associated with 0, 25, and 100% values, respectively. 0 and 100%
values can be stored by entering a value and then holding down the corresponding function
key. The 25% key will then automatically step through the 25% values.

Figure 4. The Menu Tree

LIGHT

Home Menu

CONFIG

Selection Menu

SELECT

Parameter Selection

DONE

FREQ LEVEL

Frequency Level

DONE

If calibrator is in
Frequency Out
or Pulse mode

CONTRAST

Contrast Menu

DONE

AUTO OFF

Auto Off Menu

DONE

LIGHT

AUTO FUNC

Auto Function Menu

DONE

If calibrator is in
Source mode