MAGURA HYMEC User Manual - Manual (Page 16)

Ramp assembly
End cap
Cable coupling
Ball on cable end
1
HYMEC-inStallation > bUEll Xb-MoDElS
inStrUCtion
> Remove the clutch cover on the left-hand side of the motor.
> Remove the clutch cable by taking off the nut with spring and then backing off the adjusting screw of the
clutch with the screwdriver and so that the ramp assembly can be rotated. Remove the cable coupling
from the outer ramp. Then remove the clutch cable from the primary cover. Remove the mechanical clutch
lever from the handlebar.
> Reinstall the cable coupling and the ramp assembly; set the clutch according to the factory instructions
(loosen the counter nut; screw it in as far as it will go and then 1/2 to 3/4 revolutions back; replace nut
with spring).
> Remove the hydraulic system from the packaging.
toolS rEqUirED
> 8 mm wrench
> 14 mm wrench
> Torx wrench set
> Medium-sized screwdriver
> Wire cutter or sharp knife
On delivery, the system is completely filled. The system must be opened for installation. No fluid may be
allowed to escape as this could subsequently impair the proper functioning of the system. It is therefore
essential that the following installation instructions be followed exactly. To ensure a precise fit, the hydraulic
system is locked with a spacer in the slave cylinder during installation. Do not actuate the master cylinder
prematurely! Do not remove the spacer prematurely; remove it according to the instructions!
If additional
hydraulic fluid is required, use only MAGURA mineral oil; available in either 2 or 10 ounce bottles.
16