KYORITSU KEW Windows for KEW 3127 Windows Vista/7/8 - Manual (Page 2)

07-14 92-2169A
（ For Windows XP）
(1) Connect your PC and the product with MODEL8212 USB.
After connecting them properly, the following balloon
appears.
(2) Do the following step (4) to (8). Then the balloon shown
below appears.
Repeat step (4) to (8) to complete installation.
(3) The Found New Hardware Wizard pop-up appears after
the balloon shown at (1) is displayed. Select "No, not this
time.", and click“Next”.
(4) Select“Install from a list or specific location”, and
click“Next”.
(5) Select“Search for the best driver in these locations.”
and check the boxes for“Search removable media
[floppy, CD-ROM…]”and“Include this location in the
search:”, and then click“Browse”.
(6) If the CD is not inserted, close the window once by
clicking "Cancel" and select again after inserting the CD.
(7) If the following warning message appears, click
“ Continue Anyway”.
(There is no problem to continue installing because
operation has already been verified.)
(8) Installation is completed when the wizard finishes. Click
“ Finish”.
(9) The following underlined two icons will appear in the
Device Manager when the driver is successfully installed.
(For Windows 8)
When the balloon shown below appears after connecting the
USB cord to the PC, please install the USB driver according
to the following procedure.
(1) Go to“Control Panel”, and then to“Device Manager”.
* If the displayed Control Panel is similar to the one shown
below, change the View by Category to Large icons.
(2) Cl i ck“ O t h e r d ev i ce s”a n d t h e n r igh t- cl i ck o n
“ MODEL8212 USB”.
Then click“Update Driver Software”.
(3) Select“Browse my computer for driver software”.
(4) Then click“Browse…”.
(5) Select the disk drive in which the CD resides and click
OK. If the CD is not inserted, close the window once by
clicking "Cancel" and select again after inserting the CD.
(6) Click“Install”if the following warning window appears.
(There is no problem to continue installing because
operation has already been verified.)
(7) Installation is completed when the wizard says
“ Windows has successfully updated your driver
software”. Click“Close”.
(8) Click“Other devices”under the Device Manager, and then
right-click on“USB Serial Port”. Then click“Update
Driver Software”.
(9) Repeat above step (3) through (6). The wizard says
“ Windows has successfully updated your driver
software”when the driver is successfully installed, and
the following underlined two icons will appear in the
Device Manager.
4. Starting the“KEW Windows for KEW3127”
Turn the Bluetooth off to establish communication with
application by using MODEL8212 USB. Otherwise,
communication with application cannot be made. For details
on how to turn on/off Bluetooth, please refer to instruction
manual for the product.
Click the“KEW WindowsV2”icon on your desktop, or click
“ Start”->“Program”->“KEW”->“KEW WindowsV2”.
Ensure that KEW3127 gets started before connecting
KEW3127 to your PC. Then start KEW WindowsV2.
The main window for“KEW WindowsV2”appears. Select
“ KEW3127”and click“Start ”or double click on the
“ KEW3127”to get the KEW3127 started. Click“Close”or
close button (x) on the right-top to end the program.
MEMO MEMO