KYORITSU 6050 - Manual (Page 27)

̶ 25 ̶
7.2.3 Testing
(1) Press the TEST BUTTON.
(2) Measured result is displayed on LCD.
If the measured result is 100V or more, "UcH V" is displayed on
LCD.
Note： When Test Lead removed during a measurement, "no" is
displayed on LCD and a measurement will be stopped. Please
check Test Lead is rightly connected.
If "I⊿n" setting is grater than the rated residual current of RCD,
RCD will trip and "no" may be displayed on LCD.
8. AUTO-TEST
When applying voltage to the instrument, with Test button is turned and
being locked, voltage value is displayed on LCD. And 3sec. later, a
measurement on selected function is performed automatically. Be sure
to release the locked Test button after a measurement.
9. STORE / RECALL A MEASURED RESULT
Measured result at each function can be stored in the memory of the
instrument. (MAX : 300)
9.1 How to store data
Store the result according to following sequence.
(1) After a measurement, press MEMORY MODE SWITCH ("MEM
MODE" SWITCH) while measured result is being displayed. Then
instrument becomes MEMORY MODE, and " MEM " mark appears
on the LCD. The action of each switch changes as shown under
each switch.
(2) Select the Data No you want to store with MEMORY SELECT
SWITCH ("MEM ▼▲ "SWITCH).
(3) Decide it with ENTER SWITCH("ENT" SWITCH).
(4) Select the Place No you want to store with MEMORY SELECT
SWITCH ("MEM ▼▲ "SWITCH).