KYORITSU 6017 - Manual (Page 11)

9
5. Preparation for Measurement
5-1 Installing Batteries
WARNING
¡ To avoid possible electric shock hazard, set the function selector switch to
the OFF position and remove the test probe connector from the socket
before opening the battery compartment cover. After battery replacement,
do not use the instrument before securing the cover with the two screws.
¡ Never mix old and new batteries.
¡ Install batteries in correct polarity as shown inside the battery
compartment.
1. Set the range selector switch to the OFF position and remove the test probe
connector from the probe socket.
2. Open the battery compartment cover by removing the two screws on the bottom
of the instrument. Replace all eight batteries with new ones.
3. Secure the cover in place with the two screws.
Battery-compartment-cover-fixing Screws
Note:
¡
When not in use for a long time, to prevent possible corrosion caused by battery
leakage, remove the batteries before storage.