KROHNE OPTISENS PH 9500 - Manual (Page 23)

OPERATION
4
23
OPTISENS PH 9500
www.krohne.com 08/2012 - 4001929601 MA OPTISENS PH 9500 R01 en
4.2 Function tables
4.2.1 Menu A, quick setup
A9, ph cal. B
A12, process input B ORP calibration
A13, process input B pH calibration
Measuring
mode Main menu Submenu Parameter
3 or 4
pages,
scrolling
with ↓ or ↑
> 2.5
s
^
C
setup
>
^
C1 process input A >
^
C1.1 parameter (pH/ORP) >
^
For further
information
see function
tables.
C1.7 inner buffer (only pH)
C1.8 zero point
C1.9 slope
C1.10 calibration buffers
C1.14 time constant
C1.15 temperature
C1.16 ORP cal.
C1.17 pH cal.
C2 process input B
(for dual channel version;
refer to pH/ORP sensor
manual for further
information)
C2.1 parameter (pH/ORP)
C2.7 inner buffer (only pH)
C2.8 zero point
C2.9 slope
C2.10 calibration buffers
C2.14 time constant
C2.15 temperature
C2.16 ORP cal.
C2.17 pH cal.
↓↑ ↓↑ ↓↑ ↓↑
INFORMATION!
Note that the appearance of some sub-menus depends on the hardware setting and the used
sensor(s). Also only the sensor relevant menus and submenus are shown here in detail. For all
other menu functions refer to the MAC 100 signal converter manual.
For single or dual channel version: Settings for sensor calibration
For dual channel version; refer to pH/ORP sensor manual for further information.
Only if switched to ORP!
For dual channel version; refer to pH/ORP sensor manual for further information.