KROHNE OPTISOUND 3040 C 4wire EN - Manual (Page 14)

1
2
3
4
5
Fig. 5: Assembling – version B
1 Groove for locking the housing
2 Marking notch
3 Screw of swivelling holder (hexagon SW 13)
4 Screws of fixing ring (hexagon spanner - size 4)
5 Screws of housing (hexagon spanner - size 4)
Version C is supplied in three parts:
l
Transducer
l
Transducer cable
l
electronics for wall mounting
Assemble the version as follows:
1 Loosen the screws on the fixing ring (4) with a hexagon
spanner (size 4), remove the transducer tube out of the
swivelling holder
2 Mount the flange
3 Insert the transducer tube in the requested length from
below into the swivelling holder
4 Fasten with screws (4); torque max. 10 Nm
5 Remove the plug from below out of the connection cylinder
and plug it into the socket of the transducer tube
6 Plug the connection cylinder to the transducer tube. Do not
squeeze any cables. The cylinder is in the correct position,
if the lower notch (2) of the transducer tube is no longer
visible
Assembly – version C
14 OPTISOUND 3040 C - 4 ... 20 mA/HART - four-wire
Mounting
30515
-EN
-050914