KROHNE CORIMASS MFC 85 EN - Manual (Page 6)

6
3.2 Displaying Concentration and Solute Flow Values
Table 3.2 shows the measured values available for display on the converter with the
concentration systems. All options have a Concentration by Mass display, (in units of °Brix,
°Baumé or just as a percentage), and a solid flow rate display. The General Concentration
option also has a percentage by volume display.
The control of these displays are basically the same for all systems, please refer to the
Standard operating manual. Using NaOH as an example, starting from measuring mode:
Key Line 1 Line 2 Comments
→↑↑
Fct. 3.(0) INSTALL
→↑
Fct. 3.(2).0 DISPLAY
→↑
x8 Fct. 3.2.(9) SOLUTE.FLOW
→
(OFF) Display disabled
↑
00000.000 (g)/min Display enabled, use
↑
key
to select mass units
↑
00000.000 (kg)/min
→
00000.000 kg/(min) Use the
↑
key to select
time units
→
00000(.)000 kg/min Use the
↑
key move the
decimal point
↑
000000(.)00 kg/min
↵
Fct. 3.2.(9) SOLUTE.FLOW
↑
Fct. 3.2.(10) CONC.BY.MASS
→
(OFF) Display disabled
↑
000000.00 (PERCENT M) Display enabled
↵
Fct. 3.2.(10) CONC.BY.MASS
↵
x4 Exit menus and save changes
Table 3.2.1 Measurement Display variations for Concentration systems
Concentration Option
NONE BRIX BAUMÉ GEN. CONC. NaOH
MASS FLOW MASS FLOW MASS FLOW MASS FLOW MASS FLOW
MASS TOTAL MASS TOTAL MASS TOTAL MASS TOTAL MASS TOTAL
DENSITY DENSITY DENSITY DENSITY DENSITY
TEMPERATURE TEMPERATURE TEMPERATURE TEMPERATURE TEMPERATURE
VOLUME FLOW VOLUME FLOW VOLUME FLOW VOLUME FLOW VOLUME FLOW
VOLUME TOTAL VOLUME TOTAL VOLUME TOTAL VOLUME TOTAL VOLUME TOTAL
BRIX BAUME PERCENT M. PERCENT M.
SUCROSE FLOW SUCROSE FLOW PERCENT V. SOLID FLOW
SOLID FLOW
BOLD type indicates displays that are permanently enabled. All other displays must be
specifically enabled in the corresponding Fct 1.2 or 3.2 menu.