KROHNE OPTISOUND 3000 Series EN - Manual (Page 18)

Simulation
Simulation
start?
With the reset function, modified values are reset. Three
subfunctions are available:
l
Basic adjustment
- Reset of the values modified with the indicating/
adjustment module to the sensor-specific basic
setting (see chart)
l
Factory setting
- Like basic setting, but also reset of special
parameters modified with PACTware™ to deli-
very status
l
Peak values measured value and temperature
- Reset of the min./max. values of level and
temperature to the current values
Reset values basic setting
Menu Menu item Ultrasonic
Basic setting Units of measurement deleted
Min. adjustment upper dead zone depending on instru-
ment
Max. adjustment end nominal measuring range
Linearization curve linear
Sensor-TAG Sensor
Display Displayed value 1 Distance
Scaling 0% = 0.0, 100% = 100.0
Service Current output
Output mode: 4-20mA
Failure mode: < 3.6 mA
min. current3.8 mA
Reset
18 Indicating/adjustment module for OPTISOUND sensors
Set up
30603
-EN
-050401