KROHNE OPTISOUND 3000 Series EN - Manual (Page 14)

keys are shown in the above illustration. Approx. 10
minutes after the last pressing of a key, an automatic
reset to measured value indication is triggered. Any
values not confirmed with [OK] will not be saved.
5.2 General functions
OPTISOUND ultrasonic sensors have various functions.
Therefore they can be adapted perfectly to the respec-
tive application. These functions are structured in menu
form. Some of the functions are sensor-specific. These
are described in the operating instructions manual of the
respective sensor. Other functions, however, have
general character, i.e. they are available in sensors with
different measuring principles.
The general functions are described in this paragraph.
The functions of the indicating/adjustment module are
determined by the sensor and correspond to the
respective software version of the sensor.
Information:
The respective menu item number differs depending on
the sensor type and signal output.
The following presentations are available in the mea-
sured value display:
l
Level as digital value, sensor TAG
l
Level as digital value and bar graph, sensor TAG
With [–>] you select the different presentations of the
measured value. From all presentations you reach the
menu overview with [OK]. With [ESC] you return from
the menu overview to the measured value display.
In the menu overview you select the respective menu
with [–>] and finally reach it with [OK]. Then the
individual menu items are available.
>
Basic adjustment 1
Display
Diagnostics
Service
Info
Introduction
Measured value indication
Menu overview
14 Indicating/adjustment module for OPTISOUND sensors
Set up
30603
-EN
-050401