KROHNE OPTIFLEX 1100C Quickstart EN - Manual (Page 9)

INSTALLATION
2
9
OPTIFLEX 1100 C
www.krohne.com 01/2012 - 4001226201 - QS OPTIFLEX 1100 R01 en
• Cut the last segment of tube.
• Attach the last segment of tube.
• Attach the probe end cap 2 to the end of the tube. Tighten lock screw 3 with a 3 mm Allen
wrench.
Adjust the probe length to the tank height
Figure 2-7: How to assemble the segmented coaxial probe
1 Coaxial probe: Last segment of the tube
2 Probe end cap
3 1 HC M6×5 lock screw
4 Bonded plastic spacer
CAUTION!
Before you cut the tube, disassemble the last segment of tube from the coaxial probe and
remove the signal cable.
After you tighten the lock screw, it will not be possible to disassemble the coaxial probe.