KROHNE OPTIFLEX 1100C Quickstart EN - Manual (Page 14)

2
INSTALLATION
14
OPTIFLEX 1100 C
www.krohne.com 01/2012 - 4001226201 - QS OPTIFLEX 1100 R01 en
2.4 How to install a device with a threaded connection
Equipment needed:
• Gasket (not supplied with G (ISO 228) threaded connections)
• 34 mm wrench (not supplied)
2.5 How to turn or remove the signal converter
How to remove the signal converter
• Loosen the lock screw with a 5 mm wrench.
• Remove the signal converter from the probe assembly.
• Put the cover 3 on the probe assembly.
Figure 2-14: How to turn or remove the signal converter
1 Signal converter
2 Process connection and probe assembly
3 Cover for the coaxial hole on top of the process connection assembly
CAUTION!
When the housing is attached to the process connection assembly, make sure that the lock
screw is tight.