KROHNE DA Flap-type EN - Manual (Page 3)

Product liability and warranty
The flowmeter is suitable for measuring the volume flow of liquids.
Special regulations apply for use in explosion-hazardous areas. (Refer to the section on the scope of delivery.)
Responsibility for the suitability and usage to the intended purpose of these flowmeters rests solely with the operator.
Improper installation or improper operation of the flowmeters may lead to the loss of warranty. In addition, the "General
conditions of sale" which form the basis of the purchase contract are applicable.
The calculation of the pressurized parts is effected with allowance for corrosion, erosion through abrasion or cavitation.
If the flowmeter needs to be returned to KROHNE Messtechnik, please note the information at the end of these
installation and operating instructions.
Scope of delivery
● Installation and operating instructions Ident. No.: 702124##00
● Supply without installation accessories (screw bolts, flange seal and cabling)
Special certificates (supplied to order only)
● Test certificate to EN 10204:
● Pressure test, paint penetration test, irradiation test, leak test,
ultrasonic test, heIium leakage test,
● Cleaning pursuant to works regulations
● Calibration certificate