KROHNE ALTOSONIC V Installation EN - Manual (Page 3)

04/2012 www.krohne.com 3
ALTOSONIC V
1
Disclaimer
This document contains important information on the instrument. KROHNE attempts to
be as accurate and up-to-date as possible but assumes no responsibility for errors or
omissions. Nor does KROHNE make any commitment to update the information
contained herein. This manual and all other documents are subject to change without
prior notice.
KROHNE will not be liable for any damage of any kind by using its instrument, including,
but not limited to direct, indirect, incidental, punitive and consequential damages.
This disclaimer does not apply in case KROHNE has acted on purpose or with gross
negligence. In the event any applicable law does not allow such limitations on implied
warranties or the exclusion of limitation of certain damages, you may, if such law applies
to you, not be subject to some or all of the above disclaimer, exclusions or limitations.
Any instrument purchased from KROHNE is warranted in accordance with the relevant
product documentation and our Terms and Conditions of Sale.
KROHNE reserves the right to alter the content of its documents, including this
disclaimer in any way, at any time, for any reason, without prior notification, and will not
be liable in any way for possible consequences of such changes.
Product liability and warranty
Responsibility for suitability and intended use of this ultrasonic flow meter rests solely
with the user. Improper installation and operation of the flow meter (system) may lead to
loss of warranty.
In addition, the Terms and Conditions of Sale are applicable and are the basis for the
purchase contract.
If flow meters need to be returned to KROHNE, please note the information given on the
last pages of the installation and operating instructions. KROHNE regrets that they
cannot repair or check flow meter(s) unless accompanied by the completed form (see
last pages of the installation and operating instructions).
Items supplied
Standard (OIML type tested)
 1x UFS 500 F/5STR-EEx ultrasonic flow tube, in the size as indicated on the packaging
box, including 4 certified EEx i M20X1,5 cable glands in connection box: 3 for the
sensor cables and 1 for the PT100 sensor to measure the body temperature.
 1x UFC-V/EEx (standard or with optional 30 W heater) or UFC-V/LT-EEx (low-
temperature) ultrasonic Flow Converter, containing 5 UFC 500 converters and if
ordered a heating device, including 3 certified EEx d M20X1,5 cable glands in junction
box for connecting supplied coaxial cable.
 3x Sensor cables with 4 coaxial cables, each with preassembled SMB connectors for
the interconnection of the ultrasonic transducers of the UFS-V to the converter
electronics of the UFC-V, standard length 5 or 10 meters, flame retardant
according IEC 332-1 3rd.
Optional
 1x Flow processor UFP-V, 19" rack version to process the flow, temperature, pressure
and density signals into a volume flow output as well as internal totalizers and
Modbus data.
 1x 19” I/O-rack. This rack contains all the connection terminals to the I/O devices. It
contains the ordered I/O modules which are interfaced to the UFP-V Flow Processor.
This part is custom pre-wired and also ready to use.