KROHNE IFC 300 Converter HART 0201 - Manual (Page 17)

Supplementary Handbook IFC 300 HART, FC375, AMS, PDM, DTM
Configure
Compare
Clear Offline
-----------------------------------
Status/Conditions
Process Variables
Scan Device
-----------------------------------
Calibration Management
Diagnostics and Test
Calibrate
Reset
Basic Configuration
-----------------------------------
Rename
Unassign
Assign / Replace
-----------------------------------
Audit Trail
Record Manual Event
Drawings / Notes ...
Help ...
IFC 300 HART Menu Tree AMS
Simulation current output A/C Opt, Cust
Simulation current/frequency output A Opt, Cust
Simulation current/frequency output B Opt, Cust
Simulation frequency output D Opt, Cust
Circuit Board Info
Autom. zero calibration Cust
D/A trim Cust
Apply values Cust
Reset Errors
Reset Configuration Changed Flag
Master Reset
Warmstart
Reset Counter 1
Cust
Set Counter 1 Cust
Reset Counter 2 Cust
Set Counter 2 Cust
Reset Counter 3 Opt, Cust
Set Counter 3 Opt, Cust
process values:
• volume flow
• mass flow
• flow speed
• conductivity
• coil temperature
• diagnosis value
Opt
outputs:
• A
Opt
• % range A Opt
• B Opt
• % range B Opt
• C Opt
• % range C Opt
• D Opt
• % range D Opt
Device:
• tag
Rd
• descriptor Rd
HART:
• Polling Address
Rd
• Device ID Rd
counter:
• counter 1
Opt
• counter 2 Opt
• counter 3 Opt
Designations:
Opt Optional, dependent on device
implementation / configuration
Rd Read-only
Cust Custody Lock protected
Loc Local AMS, affects only AMS views
KROHNE IFC 300 HA 45e30201 (5/5)
04/06
1,2,3
4
Select Measurement Counter 1
Select Measurement Counter 2
Select Measurement Counter 3
Opt
Select Diagnosis Value
HART_Suppl_IFC300_V0201.DOC
04/2007
17/23