Acura 2011 RDX - Manual (Page 90)

If DEFAULT ALL is not set, you will
see the above display for several
seconds, then the screen goes back
to CUSTOMIZE ENTRY. Repeat the
procedure to select DEFAULT ALL. If you want to cancel DEFAULT ALL,
select EXIT, then press the SEL/
RESET button. The screen goes back
to CUSTOMIZE ENTRY.
Change Settings
You can customize some of the
vehicle control settings to your
preference. Here are the settings you
can customize:
●
METER SETUP
● LIGHTING SETUP
● DOOR SETUP
While CHG SETTING in the
CUSTOMIZE ENTRY is shown on
the multi-information display, press
the SEL/RESET button. The screen
changes to METER SETUP in the
CUSTOMIZE GROUP.
Each time you press the INFO ( /
) button, the screen changes as
shown on the next page. Press the
INFO ( / ) button, until you see
the setup you want to customize,
then press the SEL/RESET button to
enter your selection.
Multi-Information Display
86
10/06/08 17:42:32 11 ACURA RDX MMC North America Owner's M 50 31STK640 enu
2011 RDX