KEPCO KLP Series Quick Start Guide, P/N 228-1773 - Manual (Page 3)

091713 228-1773 REV 1
3
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
ACCESSORIES. See Table 3.
SAFETY. See Table 4
TABLE 3. ACCESSORIES
ITEM FUNCTION
KEPCO
PART NUMBER
Line Cord Set (125V/20A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 5-20R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 90-136V a-c. NEMA 5-20R 118-0776
Line Cord Set (125V/15A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 5-15R receptacle
(see adjacent figure). Supports restricted load
power over mains voltage range of 90-136V a-c
(contact Kepco Sales Engineering for details). NEMA 5-15R 118-1136
Line Cord Set (250V/15A) 2.5m long cord set, provides for source power
connection. Mates with NEMA 6-15R receptacle
(see adjacent figure). Supports rated load power
over mains voltage range of 180-265V a-c. NEMA 6-15R 118-1137
Source power connector Mates with a-c input connector J1 (see Figure 1-2). Allows user to
fabricate custom line cord. 142-0381
IEEE 488 (GPIB) Cable, 1m long Connect KLP Power Supply to GPIB bus. SNC 488-1
IEEE 488 (GPIB) Cable, 2m long Connect KLP Power Supply to GPIB bus. SNC 488-2
IEEE 488 (GPIB) Cable, 4m long Connect KLP Power Supply to GPIB bus. SNC 488-4
Chassis Slide Allows rack-mounted units to slide in and out. Two (2) slides required
per power supply. 108-0239
(Jonathan
375-QD Series)
Analog Connector Backshell Locks analog port mating connector to KLP via jackscrews. 108-0204
Loop Back Test Connector Used for verification of RS 232 operation. 195-0112
Null Modem Cable, 10 ft. Connect RS 232 port with controlling computer, DB9F to DB9F, 10 feet
long. 118-1176
Null Modem Cable, 1 ft. Used for Master/Slave connections. Connects RS 232 ports of stacked
power supplies, DB9F to DB9F, one foot long. 118-1220
LAN Patch cable Connects KLP LAN port to LAN, 10 ft long. 118-1115
Support bracket, rear Provides extra support to rear of rack-mounted unit if needed. Two
brackets required per unit. Each bracket requires 2 screws and 2
washers. See Figure 4, sheet 1, Detail “A” for requirements. 128-2306
TABLE 4. SAFETY SYMBOLS
SYMBOL MEANING
CAUTION: RISK OF ELECTRIC SHOCK.
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING INDICATES THE POSSIBILITY OF BODILY INJURY OR DEATH.
CAUTION INDICATES THE POSSIBILITY OF EQUIPMENT DAMAGE.
!