KEPCO CS 06 Chassis Slides (for EL Series Electronic Load) - Manual (Page 2)

2
228-1734 REV 1 061711
KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A. TEL (718) 461-7000 FAX (718) 767-1102
http://www.kepcopower.com email: [email protected]
2.2 PROCEDURE (SEE FIGURES 2, 3 AND 4.)
1. The slides are shipped pre-assembled. Press lock button and separate chassis section of each slide from
intermediate section (See Figure 1).
FIGURE 1. SEPARATE CHASSIS SECTION
2. Attach two chassis sections of slide to each side of Electronic Load using seven black screws (P/N 101-
0531): four on one side and three on the other side (see Figure 2).
CAUTION: Using screws other than those specified will damage
the unit and void the warranty.
FIGURE 2. INSTALLING CHASSIS SECTION ON ELECTRONIC LOAD CHASSIS
3043551
CHASSIS
SECTION
INTERMEDIATE
SECTION
CABINET
SECTION
PRESS LOCK BUTTON TO
SEPARATE CABINET SECTION
FROM INTERMEDIATE SECTION.
!
3043550
MACHINE SCREW (5),
10-32 x 1/4 PH PAN HEAD
(KEPCO P/N 101-0531)
CHASSIS
SECTION
EL SERIES
ELECTRONIC LOAD
CHASSIS
SECTION
MACHINE SCREW (4),
10-32 x 1/4 PH PAN HEAD
(KEPCO P/N 101-0531)