SilentKnight VisorAlarm Plus 2U - Manual (Page 20)

With this option the receiver does not apply any filters and displays all the stored signals
beginning with the most recent.
Each signal is displayed as in the next figure:
16:33:23 00001234
E110 01 001 Fire
The list can be navigated using the e and f keys. Use the left arrow to go to a newer signal
and the right one to go to an older one.
If the OK key is pressed while one signal is being displayed, extended info for that signal is
shown on the display:
By pressing OK again the previous view is recovered.
2. Search only the System Troubles.
System troubles are unrestored trouble signals generated by the receiver itself. The signals
generated by the VisorALARM PLUS 2U receiver always have the 00000000 account code
that is reserved and cannot be assigned to a mIP/IPDACT device.
The set of trouble signals that VisorALARM PLUS 2U can raise is described in the next table:
Trouble signal Description
Hdw failure: Fan 0 Fan #0 has failed
Hdw failure: Fan 1 Fan #1 has failed
Hdw failure: LCD Failure in the LCD device
Hdw failure: Buzzer Failure in the Local Piezo Sounder
Hdw failure: Printer Printer not detected
Network failure The device specified in the monitor_ip_address
configuration parameter does not answer.
Probably the internet link is down
Receiver is down The receiver cannot receive signals
Primary is down The Backup receiver has detected that the Primary
receiver is down
Backup is down The Primary receiver has detected that the Backup
receiver is down
Storage full Received signals queue is full
Time is inaccurate The NTP server specified in the NTP configuration
does not answer.
The synchronization of the Primary and Backup
receivers can fail
Signal DB overflowed The stored signals database has been overwritten
11/17/06 16:33:23
00001234 E110 01 001
VisorALARM PLUS 2U Operating
III - 18
Doc.DM375-I
Ver.2.0