Detcon SW-V1-DV2 - Manual (Page 6)

SW-V1-DV2
SW-V1-DV2 Instruction Manual Rev.0.0 Page 2 of 7
If the unit uses the RXT-320 Transceiver, the rotary switch on the Wireless Alarm Interconnect PCA is used to
set the Modbus Address of the alarm unit. If more than one alarm station used in the system, each alarm
station must have a unique address for the alarm station to be recognized on the network properly. This switch
is not used with the RXT-300 Transceivers.
1.1 Strobe
The alarm station warning light is configured with choice of dome colors such as amber, blue, clear, green,
magenta, or red. Dome guard is included. The rugged warning light is specifically designed for hazardous
locations or corrosive environments where a very bright visual signal is required.
Figure 3 Strobe
1.2 Smart Battery Pack
Figure 4 Smart Battery Pack
The Wireless Alarm Station assembly also comes with a battery pack that allows the assembly to be remotely
mounted without the need for any cables because of its wireless operation. Detcon has several options for
battery packs. The battery packs provided are Detcon’s plug-in Smart Battery Packs which provides an output
of 12VDC (See Figure 4). The battery packs consist of rechargeable Lithium-Ion batteries and are equipped
with integrated safety electronics that include fuel gauge, voltage, current and temperature monitoring