Detcon TP-624D - Manual (Page 18)

Model TP-624D
TP-624D Instruction Manual Rev. 0.4 Page 14 of 40
3.2 Operator Interface
The operating interface is menu-driven via the two magnetic program switches located under the target marks
of the sensor housing. The two switches are referred to as “PGM1” and “PGM2”. The menu list consists of
three major items that include sub-menus as indicated below. (Refer to the complete Software Flow Chart.)
Normal Operation
Current Reading and Fault Status
Calibration Mode
AutoSpan
Program Mode
View Sensor Status
Sensor Model Type
Current Software Version
Range of Detection
AutoSpan Level
Days Since Last AutoSpan
Remaining Sensor Life
Sensor Heater Power
Sensor Heater Voltage
Raw Sensor Resistance
mA Output
Input Voltage Supply
Sensor Temperature
Serial ID
Alarm 1 Level
Alarm 1 Ascending
Alarm 1 Latching
Alarm 1 Energized
Alarm 2 Level
Alarm 2 Ascending
Alarm 2 Latching
Alarm 2 Energized
Fault Latching
Fault Energized
Set AutoSpan Level
Set Range
Set Heater Power
Signal Output Check
Restore Default Settings
Set Serial ID
Alarm 1 Settings
Alarm 2 Settings
Fault Settings