Detcon TP-700 - Manual (Page 42)

Model TP-700
TP-700 Instruction Manual Rev. 3.5 Page 38 of 38
9.3 Model TP-700 Engineering Drawings
1) TP-700 Series Breakaway and Wiring
2) TP-700 Series Wiring and Dimensional, 316 SS condulet
3) TP-700 Series Wiring and Dimensional, Aluminum condulet
10. Revision Log
Revision Date Changes made Approval
2.3 12/16/2008 Previous revision. N/A
2.4 04/25/2011 Removed Teflon note in Section 2.5. Added Revision Log
Section 10.
LU
2.5 07/11/2011 Added inrush current information to Specifications section.
Addend wiring and dimensional drawing for aluminum condulet LU
2.6 04/16/2012 Changed the use of cable type, made changes to the Modbus
Register Map. LU
2.7 08/07/2012 Updated spare parts list, corrected specifications BM
2.8 01/07/2013 Updated ATEX approvals label, updated EN standards that
sensor assembly meets. Updated ATEX listing in Specifications BM
2.9 04/02/2013 Updated ATEX installation instructions regarding use of ring
terminal for earth ground using screw and lock-washer. Updated
guidelines for metric special fasteners used in 700 assembly BM
3.0 10/25/13 Updated for 4-20mA errors LU
3.1 11/20/13 Correct Modbus™ Register Map LU
3.2 12/19/13 Update Calibration to include Wind Guard BM
3.3 02/28/14 Update 4-20mA wiring, and specifications BM
3.4 03/07/14 Add notation on use of desiccant pack with sensor cell BM
3.5 08/07/14 Updated Calibration Section BM
Shipping Address: 4055 Technology Forest Blvd., The Woodlands Texas 77381
Mailing Address: P.O. Box 8067, The Woodlands Texas 77387-8067
Phone: 888.367.4286, 281.367.4100 • Fax: 281.292.2860 • www.detcon.com • [email protected]