DeFelsko PosiTector 200 v.1.2 - Manual (Page 18)

Returning for Service Returning for Service
T T echnical Dat echnical Dat a a
USE ONLY AA ALKALINE BATTERIES. Nickel-cadmium and nickel-metal hydride
rechargeable batteries will work but the low battery symbol may stay on.
NOTE: To retain all user settings and stored memory readings, open the battery
door only after the Gage has automatically powered down.
Before returning the Gage for service…
1.
Install new Alkaline batteries in the proper alignment shown on the door.
2. Examine the probe tip for dirt or damage.
3. Perform a RESET. (pg.10) and a ZERO (pg.6)
4. Place a plastic shim onto a hard, flat surface (i.e. glass) and attempt a
measurement. (see pg.12)
If you need to return the Gage for service, describe the problem fully and include
reading results, if any. Be sure to also include the probe and contact information
including your company name, company contact, telephone number and fax num-
ber or email address.
Measurement Range:*
Resolution:
Accuracy:
Temperature Range:
1 - 40 mils
0.1 mils
+(0.1 mils and 3% of reading)
*Range may change depending on surface roughness, temperature or coating properties.
25 - 1000 um
2 um
+(2 um and 3% of reading)
Conforms to: ASTM D 6132
0 to 40 ° C (+32 ° to +104 ° F)
Physical Specifications:
Body: 137 x 61 x 25mm (5.4” x 2.4” x 1”)
Weight: 170g (6oz) without batteries
Battery Life: 30 hours continuous
Page 18