beautypg.com

DeFelsko PosiTector 200 v.1.2 User Manual

Page 17

background image

Page 17

T

T

roubleshooting

roubleshooting

Gage does not turn on

Make sure the + and - battery terminals are positioned properly and that fresh
Alkaline batteries are being used.

Gage powers up but fails to stay on

Replace batteries with fresh Alkaline batteries. If problem persists return Gage for
service.

Gage measurements are much lower than expected

Gage may be measuring surface roughness. Raise the value of Gate A. See pg.6

Changing the Batteries

Changing the Batteries

As the batteries become weak the

symbol will appear and begin flashing

during measuring. The batteries should be changed at the earliest opportunity. The
symbol will remain on without flashing when the batteries are very weak.

Gage measurements are much higher than expected

Gage may be measuring both the coating and substrate. Lower the value of Gate
B. See pg.6

Gage does not yield accurate or consistent results

See the Set Gates (pg.6) and Adjustment (pg.7) sections to ensure the gage has
been optimized for your application. Check the Gage on traceable standards.

Make sure to hold the probe in the air and
ensure the probe is free of couplant. If problem
persists, note the error message and contact
our technical support department.

Gage displays an error message while attempting probe ZERO