Work Sharp WS2000 Tool Sharpener & Grinder Step By Step Guide - Manual (Page 22)

Before
WORK SHARP
After
WORK SHARP
Grinding or Beveling
Material on the Top
Grinding Surface
Objective:
Create a smooth, even bevel on a piece
of material
Where to Sharpen:
4 Top Side Sharpening Area
Abrasive Selection:
4 Rough Grinding: Coarse solid abrasive
(P60 – P80 grit)
4 Fine Grinding: Fine solid abrasive
(P180 – P320 grit)
Top Tips:
Use the Top Tool Rest for increased control
and safety.
Grind on the right side of the wheel so
the wheel is spinning away from you.
The outer edge of the wheel has a faster
surface speed and will grind material
faster, but with more heat. The center of
the wheel has a slower surface speed and
will grind material slower, but with less
heat.
If you grind close to the tool rest, the
material may skew sideways as the
surface of the disk is moving to your right.
Grinding at the 3 o’clock position on the
wheel will provide optimum control; since
the wheel is moving away from the edge.
Go from this...
...to this!