WEN 6501 4 x 6 Belt / Disc Sander - Manual (Page 6)

Specific safety rules for belt/disc sanders (continued)
13. Do not sand with the workpiece unsupported. Support the workpiece with the backstop or table.
The only exception is curved work performed on the outer sanding drum.
14. Always remove scrap pieces and other objects from the table, backstop, or belt before turning
the sander ON.
15. Never perform layout, assembly or set-up work on the table while the sander is operating.
16. Never use solvents to clean plastic parts. Solvents could dissolve or otherwise damage the
material. Use only a soft damp cloth to clean plastic parts.
17. Should any part of your sander be missing, damaged, or fail in any way, or any electrical
components fail to perform properly, shut off switch and remove plug from power supply outlet.
Replace missing, damaged, or failed parts before resuming operation.
18. Never pull the power cord out of the receptacle. Keep cords away from heat, oil, and sharp
edges.
19. Have an electrician replace or repair damaged or worn cords immediately.
Model: 6501 wenproducts.com 6