WEN 6501 4 x 6 Belt / Disc Sander - Manual (Page 16)

Operation
ON/OFF switch (Figure 13)
The keyed switch is intended to prevent unauthorized use of the sander.
WARNING: Remove the safety key whenever the sander is not in use. Place the key in a
safe place and out of the reach of children.
1. To turn sander ON, insert the safety key into the
key slot in the center of the switch.
2. Push key firmly into the slot, then push switch to
the ON position to start the sander.
3. To turn the sander OFF push switch to the OFF
position.
4. Remove the safety key when the sander has come
to a complete stop by gently pulling it forward
and out.
Surface or edge sanding on sanding belt
(Figure 14)
Hold the workpiece firmly with both hands. Keep
fingers away from sanding belt. Keep the workpiece
end against the backstop and move it slowly across the
sanding belt. Apply enough pressure to remove
material; excessive pressure will reduce sanding
efficiency.
Model: 6501 wenproducts.com 16