WEN 6501 4 x 6 Belt / Disc Sander - Manual (Page 11)

Assembly and adjustments (continued)
4. Peel sanding disc adhesive backing. Align perimeter of new sanding disc over the Aluminum
Disc and press firmly onto the Aluminum Disc.
NOTE: Before attaching the disc, wipe down the Aluminum Disc with denatured alcohol (shellac
thinner). This will clean the surface, leave no residue and assure a secure bond.
5. Use a screwdriver to loosen the 4 screws on the bottom of disc
cover. (Figure 5)
6. Align the 4 holes on the disc guard with the 4 holes on the
front cover, and fasten them together by 4 screws. (Figure 6)
Model: 6501 wenproducts.com 11