WEN 6501 4 x 6 Belt / Disc Sander - Manual (Page 5)

Specific safety rules for belt/disc sanders
WARNING: Do not operate this tool until it is completely assembled and installed
according to the instructions.
1. This sander is designed to sand wood or wood-like products only. Sanding or grinding other
materials could result in fire, injury, or damage to the workpiece.
2. Use the sander on horizontal surfaces only. Operating the sander when mounted on non-
horizontal surfaces might result in motor damage.
3. Fasten the sander securely to a bench top or supporting surface in order to stop it from tipping
over or moving when in use.
4. 4. Make sure the sanding belt is installed in the correct direction. See directional arrow on back
of belt.
5. Always have the tracking adjusted properly so the belt does not run off the pulleys.
6. Do not use sanding belts or discs that are damaged, torn, or loose. Use only correct size sanding
belt and disc.
7. 7. Always hold the workpiece firmly when sanding. Keep hands away from sanding belt or disc.
Sand only one workpiece at a time.
8. 8. Always hold the workpiece firmly on the table when using the disc sander and when using
the belt sander.
9. 9. Always sand on the downward side of the sanding disc when using the disc sander. Sanding
on the upward side of the disc could cause the workpiece to fly out of position, resulting in
injury.
10. 10. Always maintain a minimum clearance of 1/16 inch (1.6 mm) or less between the table or
backstop and the sanding belt or disc.
11. 11. Do not sand pieces of material that are too small to be safely supported.
12. 12. When sanding a large workpiece, provide additional support at table height.
Model: 6501 wenproducts.com 5