WEN 6501 4 x 6 Belt / Disc Sander - Manual (Page 12)

Assembly and adjustments (continued)
Mounting table for use as Disc Sander
NOTE: The Table (69) may be used as support for both horizontal and vertical applications.
1. Slide Support Shaft (76) into Bar Holder (74) aligning
flat face of the shaft with set screws and tighten securely.
Slide Support Shaft (76) into existing hole on side of
Machine Body (33) and with wrench (not supplied),
tighten Bolt (32). (See Figure 7)
Square the table (Figure 8)
To ensure accurate end sanding, the work tables must be square to the sanding surfaces prior to
using the tables for disc sanding, belt sanding, or vertical belt sanding.
1. Adjust the table to be 90° with the sanding surface.
2. Using a combination square (not provided), place one
end on the table with the ruler end against the disc
sanding surface. Check that the table is 90° to the disc
sanding surface.
3. If the table is not 90° to the sanding surface, loosen
adjusting knob (75), adjust the table, tighten the handle
and recheck with the square.
WARNING: To avoid trapping the workpiece or fingers between the table and the sanding
disc, the table edge should be adjusted to a maximum of 1/16 inch from the sanding disc.
Model: 6501 wenproducts.com 12