Universal Air Tools UT8644-H - 4 Stroke - Manual

Manufacturer/Supplier Product Type
RPM
Cycles Per Min
Tel No Fax No
(01494) 883300 (01494) 883237
Model No/Nos Serial No
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use of the Tool
The tool is designed for the purpose of chipping, riveting and
scaling of metals and stone. In general terms a reciprocating
free piston in the cylinder of the tool imparts a blow to the chisel
or working attachment. A list of suitable equipment to use with
this tool can be provided by the manufacturer. Do not use the
tool for any other purpose than that for which it was designed
without consulting the manufacturer or the manufacturer’s
authorised representative.
Do not modify the tool for it’s use as a chipper etc. or for any
other purpose without first agreeing any such modification with
the manufacturer or the manufacturer’s authorised
representative.
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured air
pressure at the tool of 90 p.s.i./6.3 bar when the tool is running
with the trigger fully depressed. Use recommended hose size
and length. It is recommended that the tool is connected to the
air supply as shown in figure 1. Do not connect the tool to the
air line system without incorporating an easy to reach and
operate air shut off valve. The air supply should be lubricated. It
is strongly recommended that an air filter, regulator, lubricator
(FRL) is used as shown in Figure 1 as this will supply clean,
lubricated air at the correct pressure to the tool. Details of such
equipment can be obtained from your supplier. If such
equipment is not used then the tool should be lubricated by
shutting off the air supply to the tool, depressurising the line by
pressing the trigger on the tool. Disconnect the air line and pour
into the hose adaptor a teaspoonful (5ml) of a suitable
Work Stations
The tool should only be used as a handheld, hand operated tool.
It is always recommended that the tool is used when standing
on a solid floor. It
can be used in other
positions but before
any such use, the
operator must be in
a secure position
having a firm grip
and footing and be
aware of a reaction
force on the hand as
result of the tool
doing work.
No
Page No 1
Chipping Hammer
UT8644-H - 4” Stroke
Outside Lever Handle
18.5
8.4 1/2 13 30 10
1,500
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
Noise Level Sound Pressure Level 94.0 dB(A)
Test Method Tested in accordance with Pneurop
test code PN8NTC1 and ISO Standard 3744
Sound Power Level 105.0 dB(A)
Vibration Level
Test Method Tested in accordance with ISO
standards 8662/1 Parts 1 & 2
11.1 Metres/Sec²
N/A
Personal Safety Equipment
Use - Safety Glasses
Yes
Use - Safety Gloves
Yes
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors
Yes
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7.0
bar
100
PSI