Universal Air Tools UT021A (HP021) - Manual

Manufacturer/Supplier Product Type
RPM
Cycles Per Min
Model No/Nos Serial No
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use of Tool
This tool is designed for the purpose of driving staples for only
the sizes as indicated in the section “Operating”. Do not use the
tool for any other purpose. Do not modify the tool to be used for
any other purpose or for its use as a stapler without first
agreeing any such modifications with the manufacturer or an
authorised distributor.
Putting Into Service
Air Supply
Use a clean lubricated air supply
that will give a measured air
pressure at the tool of 90 p.s.i./6.3
bar when the tool is running with
the trigger fully depressed. Use
recommended hose size and
length. It is recommended that the
tool is connected to the air supply
as shown in figure 1. Do not
connect the tool to the air line
Work Stations
The tool should only be used as a handheld, hand operated tool.
It is always recommended that the tool is used when standing
on a solid floor. It can be used in other positions but before any
such use, the operator must be in a secure position having a
firm grip and footing and be aware of a reaction force on the
hand as result of the tool doing work.
No
Page No 1
10mm Stapler
UT021A (HP021)
2.42
1.1 3/8 10 30 10
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a safe
accessible place.
Noise Level
Sound Pressure Level 88.4 dB(A)
Test Method
Tested in accordance with ISO
Standard 3744
Peak C Level 116.0 dB(A)
Vibration Level
Test Method
Tested in accordance with ISO
standard 8662/1
4.4
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
Tel No Fax No
(01494) 883300 (01494) 883237
Metres / Sec²
system without incorporating an easy to reach and operate air
shut off valve. The air supply should be lubricated. It is strongly
recommended that an air filter, regulator, lubricator (FRL) is used
as shown in Figure 1 as this will supply clean, lubricated air at
the correct pressure to the tool. Details of such equipment can
be obtained from your supplier. If such equipment is not used
then the tool should be lubricated by shutting off the air supply
to the tool, depressurising the line by pressing the trigger on the
tool. Disconnect the air line and pour into the intake bushing a
teaspoonful (5ml) of a suitable pneumatic motor lubricating oil
preferably incorporating a rust inhibitor. Reconnect tool to air
supply and run tool slowly for a few seconds to allow air to
circulate the oil. If tool is used frequently lubricate on daily basis
and if tool starts to slow or lose power.
It is recommended that the air pressure at the tool whilst the
tool is running is 90 p.s.i./6.3 bar. The tool can run at lower and
higher pressures with the maximum permitted working air
pressure of 100 p.s.i./7.0 bar.
N/A
N/A
Air Pressure
Recommended Working
6.3
bar
90
PSI
Recommended Minimum
n/a
bar
n/a
PSI
Maximum
7.0
bar
100
PSI
Personal Safety Equipment
Use - Safety Glasses
Yes
Use - Safety Gloves
Use - Safety Boots
Use - Breathing Masks
Use - Ear Protectors
Yes