Universal Air Tools UT5720A - Manual

Manufacturer/Supplier Product Type RPM
Cycles Per
Tel No Fax No (01494) 883300 (01494) 883237
Model No/Nos Serial No (if any)
Product Nett Weight
lbs
Kg
Recommended Use Of
Balancer Or Support
Recommended Hose Bore
Size - Minimum
Recommended Max.
Hose Length
Ins M/M Ft M
Foreseen Use Of The Tool
This die grinder is primarily designed for use with bonded
abrasive mounted point grinding wheels. It may also be used
with steel rotary files and carbide burrs provided their speed
rating matches the speed of the grinder.
This tool should not be fitted with cutting off wheels, saw
blades, drill bits, etc. If there is any doubt about the correct
use of this product contact your supplier for advice.
Also make sure that the shank size of the attachment to be
driven matches with the collet size fitted in the grinder and
that the maximum allowed running speed of the attachment
exceeds that marked on the grinder.
There are special rules governing the use of bonded abrasive
mounted point grinding wheels - for details see section
"Operating".
Putting Into Service
Air Supply
Use a clean lubricated air supply that will give a measured
air pressure at the tool of 90 p.s.i./6.3 bar when the tool
is running with the lever/trigger fully depressed. Use
recommended hose size and length. It is recommended that
the tool is connected to the air supply as shown in figure
1. Do not connect the tool to the air line system without
incorporating an easy to reach and operate air shut off valve.
The air supply should be lubricated. It is strongly
recommended that an air filter, regulator, lubricator (FRL) is
used as shown in Figure 1 as this will supply clean, lubricated
air at the correct pressure to the tool. Details of such
equipment can be obtained from your supplier. If such
equipment is not used then the tool should be lubricated by
shutting off the air supply to the tool, depressurising the line
Work Stations
The tool should only be used
as a handheld hand operated
tool. It is always recom-
mended that the tool is used
when standing on the solid
floor. It can be used in other
positions but before any such
use, the operator must be in
a secure position having a firm
grip and footing and be aware
of the extra safety precautions
that must be observed when
using Grinding Machines.
No
Air Pressure
Recommended Working 6.3 bar 90 PSI
Recommended Minimum n/a bar n/a PSI
Maximum 7 bar 100 PSI
Personal Safety Equipment
Use - Safety Glasses Yes
Use - Safety Gloves Yes
Use - Safety Boots
Use - Breathing Masks
Yes
Use - Ear Protectors Yes
Page No 1
Die Grinder
1/4” Capacity
UT5720A
1.23
0.62
3/8 10 30 10
22,000
Includes - Foreseen Use, Work Stations, Putting Into Service,
Operating, Dismantling, Assembly and Safety Rules
Operator Instructions Important
Read these instructions carefully before installing, operating,
servicing or repairing this tool. Keep these instructions in a
safe accessible place.
Universal Air Tool Company Limited
Unit 8
Lane End Industrial Park
High Wycombe
Bucks
HP14 3BY
Noise Sound Pressure Level 86.0 dB(A)
Test Method Tested in accordance with
Pneurop test code PN8NTC1 and ISO
Vibration
Test Method Tested in accordance with ISO
standard 8662/1 & 8662/17
Less than 2.5 Metres / Sec²
Sound Power Level 99.0 dB(A)