Triton RT2000 Installation Manual - Manual (Page 36)

36
RT2000 S
ERIES
- S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
4. Open the cabinet sleeve door. To
secure the fascia, five (5) screws
(K40x12 - included in accessory
kit) and three (3) thumbscrews need
to be secured. First tighten the three
(3) thumbscrews toward the bottom
(refer to Pg.31 and Figure 5 for
location of thumbscrews). Next,
install the five K40x12 screws and
secure using a phillips-head
screwdriver (Figure 6).
Figure 5. Thumbscrew (right side).
Speaker wires
3. Align the trim bracket clips with
the sleeve slots and insert until the
trim is seated on the control panel
(Figure 4).
Figure 4. Control panel trim seated on
control panel.
Figure 6. Screw locations. Figure 7. Connect ground wire.
5. Connect the ground wire from the
bill tray to the ground stud located
on the inside left of the sleeve
cabinet shown in Figure 7. Secure
with the wingnut present.